Wiley Electronics

solar mounting rails. This replaces the lay-in lug and ground wire to each module since the mounting rails can be wired to an equipment grounding terminal in the inverter or disconnect, grounding the entire assembly. This meets the requirements of UL 467 while streamlining the installation process. ETL listed to UL standards.

WEEB-9.5

The WEEB-9.5 is used for bonding modules to mounting structures when the modules are directly bolted to the rails using ¼" bolts through the mounting holes on the rear of the module frames. This type of mounting is typical on DPW systems (see Mounting Systems) and on Wattsun and Zomeworks trackers. The WEEB-9.5NL is used for bonding strong-back structure and legs to the rail where 3/8" bolts are used. Sold in packs of 10.

WEEB-UMC

WEEB UMC grounding clips are used between modules and Unirac SolarMount Standard Rails when front mount clamps are used to hold the module to the rails. One clip grounds the frame of 2 adjoining modules to one of the mounting rails. Two clips are required for each pair of modules so that the modules will be bonded to both rails. Sold in packs of 10.

WEEB-PMC

WEEB - PMC grounding clips are used between modules and SnapNrack or ProSolar rails when front mount clamps are used to hold the module to the rails. One clip grounds the frame of two adjoining modules to one of the mounting rails. Two clips are required for each pair of modules so that the modules will be bonded to both rails. Sold in packs of 10.

WEEB Lug-6.7

The WEEBLug-6.7 provides a connection to the mounting system and has lay-in provision for an equipment ground conductor. The WEEBLug-6.7 kit includes the lay-in lug, matching WEEB washer, bolt, nut, flat washer and lock washer. Two WEEB lugs and a short piece of bare wire or a WEEB bonding jumper can be used to connect across a rail splice.

WEEB BJ-6.7

The WEEB Bonding Jumper is used to electrically bond mounting rails together at a splice. Use one at each splice.